DESKTOP SOLUTION

DESKTOP SOLUTION

The portable Desktop modules are stand alone products, that provide the same performances of standard electronics. The modules can be easily reconfigured for desktop measurement.

DCB10

The module DCB10 is a 4-channel NIM power distribution and control module. All voltage outputs (±6 Volt, ±12 Volt and ±24 Volt) are protected by electronic fuses which automatically recover after short circuit. The status is displayed by LEDs. Fuse release: when current drops to less than half the maximum current, the fuse recovers. Input and output connectors are D9 Sub style.

DATASHEET

DCB104

The module DСВ104 has 4 channels current to voltage converters. The module is housed in an aluminium box.
DCB104 has on the front panel 4 input connectors and on the backside one output connector and one power connector. The module use only external power supply +24 Volt.
Special version DCB104C is a module with input and out put connectors BNC style.

DATASHEET

DCB108

The module DСВ108 has 8channels current to voltage converters. The module is housed in an aluminium box.
DCB108 has on the front panel 4 input connectors and on the backside two output connectors and one power connector. The module use only external power supply +24 Volt.

DATASHEET

DCB116

The module DСВ116 has 16 channels current to voltage converters. The module is housed in an aluminium box.
DCB116 has on the front panel 8 input connectors and on the backside four output connectors and one/two power connector/s. The module use only external power supply +24 Volt.

DATASHEET

DCB209

The DCB209 module has 8 channels low noise charge sensitive preamplifiers. Fast timing and small size make this preamplifier excellent module for small charged particle detectors or laboratory measurements. The preamplifier is optimized for high input capacitance (up to 1000pF). The module has bias input (up to 3KV) and protection circuit to avoid breakdown of the input of the preamplifier circuit.

DATASHEET

DCB215

The desktop module DCB215 is a general-purpose spectrometric amplifier for energy spectroscopy with all types of detectors. The module has unipolar output, low noise, wide-gain range and front-panel selectable time constant.
The Module DCB215 has active filter circuit to define a very symmetrical unipolar output with optimal signal-to-noise ratio over a wide range of time constants. The module DCB215 has good DC stability of the output.

DATASHEET

DCB411

The desktop module N411 has 16 channels amplifiers specially designed for HAMAMATSU MPPC S10931-050P type detector. The module has two version: with bias and without bias tension. The amplifier has 50 Ω input impedance and amplified output signal can be terminated by 50 Ω. The module has 16 input (isolated connectors - with bias tension) and 16 output LEMO type connectors, power and Bias connectors (with bias tension).

DATASHEET

DPS100

The module DSP100 is desktop power supply that provided high quality ground for preamplifiers, amplifiers and other high sensitive equipment’s. The module has all 4 voltages ±24 Volt, ±12 Volt with a maximum output power 50 Watt. This module has under voltage and overload protection. The module can be adapted for a different input AC voltages 100/240 VAC, 50-60 Hz. On the front panel the status of power supply by GREEN/RED LED is indicated.

DATASHEET

DPS101

The module DSP101 is desktop power supply. The module has all 4 voltages with a maximum output power 50 Watt. This module has over/under voltage, overload and overheat protection and can be adapted for a different input AC voltages 100/240 VAC, 50-60 Hz. On the front panel the status of power supply by GREEN/RED LED is indicated.

DATASHEET